The two-storey house at Aylesbury, England, built by the Building Research Establishment for the full-scale measurement of wind pressures has been modelled at 1:500 scale in a boundary layer wind tunnel to verify the reliability of simulation forlow-rise buildings. Describes wind tunnel tests of buildings models of 5 and 22.5 roof slope. Compares surface pressure measurements with full-scale data for various wall and roof locations. For the model terrain best modelling conditions, the results show agreement which is encouraging.
Describes continuous measurements of wind induced pressure differences across the exterior walls of two schools taken over a period of 8 months. These schools were selected from a total of eleven schools whose air leakage characteristics had been previously studied. Calculates air infiltration rates caused by wind using the measured differentials. Evaluates equivalent pressure differentials caused by wind. Calculates uniform pressure differentials caused by stack action using a computer model.
Reports project to measure wind pressures on low-rise buildings. Describes site and houses in the estate selected for investigation. Gives details of an associated experimental building. Outlines positioning of the pressure transducers andgives details of the cabling and the reference pressure system. describes velocity measurement, recording equipment and methods of calibration, processing and analysis. Gives details of records taken in tabular form.
Describes computer program used to calculate air flows and pressure differential in a building as a result of a combination of wind effect, stack action and the operation of air handling systems. Describes mathematical model of building and the assumptions and limitations of program. Gives listing of complete program.
Describes wind tunnel tests on cubical models with roof angles of 0, 15, 30 and 45 and on a wall placed in constant velocity and variable velocity air stream. Discusses the effect of velocity distribution on pressure distribution and wind loads. Presents results in the form of diagrams of pressure coefficients over the models.
Reports systematic pressure distribution measurements made on models of rectangular buildings of various heights with gabled roofs of different slopes in a wind tunnel. Describes the models and test procedure. Gives results in the form of graphs of mean pressure coefficients for different roof pitch, building height and wind direction. An appendix shows how mean pressure coefficients are obtained from section pressure coefficients, giving graphs of section pressure coefficients over the ground plan of the buildings and the raised roof structure. NOTES translation available from B.S.R.I.A.
This paper is a review of past and current research on the subject of wind loads. Topics discussed are present wind load requirements, the determination of basic design wind velocities, the structure of natural winds, wind-tunnel studies, gusts andthe vibration of structures. Gives recommendations for basic design wind velocities, increase of wind velocity with height,and formulation of shape and gust coefficients. Includes bibliography of 270 references.
Describes computer program used to calculate the air flows and pressure differentials in a multi-storey building as a result of a combination of wind effect, stack effect and the operation of air handling systems. Describes mathematical model of building and assumptions and limitations of program. Gives complete listing of program.
Describes a general model for air infiltration which will accomodate wind pressures, stack effect and ventilation openings provided the vents are either all above or all below their respective neutral pressure levels. States that main innovation of this model is expressing the infiltration as a function of the shell leakage and of the neutral heights of each face.Describes experimental method for finding the neutral pressure level. Gives typical values of parameters for tight mid-westhouses for light and strong wind.
Describes instrumentation used to measure wind pressure on two tall buildings in central London. Describes pressure transducer which gives an electrical output suitable for use in conjunction with standard types of commercial recording equipment. Describes site installation and recording equipment which produces multi-channel records in ultra-violet sensitive photographic paper. The records are processed and digitised and several computer programs have been written to analyse this data.
Login