Steven J. Emmerich, Steven J. Nabinger, Arpita Gupte, Cynthia Howard-Reed
Bibliographic info:
BUILDING SIMULATION, 8, 2003, Eindhoven, Netherlands, p. 299-306

To   provide   additional   validation   data   for   the multizone airflow and contaminant model, CONTAMW, experiments were performed in an occupied 3-story townhouse in Reston, VA. A tracer gas, sulfur hexaflouride (SF6), was manually injected within one room of the house and the concentration of SF6 was measured in each zone. This same process was then recreated in CONTAMW and the resulting predictions were statistically compared to the measured values. A total of 10 experiments were conducted and simulated between May 2000 and June 2001. The tests involved injecting 1500 mL of 1 % SF6 in a single room of the house. In 4 of the 10 cases, the heating and air-conditioning system fan was operating. SF6  was injected in the Recreation Room (basement level), the Kitchen/Dining Room (main level) and the Master Bedroom (upstairs level). Ambient conditions ranged from a low outdoor temperature of 5 °C to a high of 29 °C. Wind conditions ranged from calm to moderate with a high average wind speed of 4 m/s. A   statistical   comparison   of   measurements   and predictions was performed per ASTM D5157 (ASTM 1997) for all cases. Comparisons were made for overall zone average concentrations and individual zone transient concentrations. The results for zone average concentrations were very good with many cases meeting most or all of the D5157 criteria. Several cases showed a poor to fair correlation between average measurements and predictions due to discrepancies with a single zone - the main floor bathroom - but excluding that zone resulted in these cases meeting or nearly meeting the D5157 criteria. Comparisons of individual zone transient concentrations were mixed with many good to excellent cases but also numerous fair to poor. As expected, there were frequently large differences between measured and predicted  peak concentrations. Also, the bathroom zone was a consistently difficult zone to predict accurately. Other zones had occasional poor comparisons between predictions and measurements but no consistent discrepancies. The predicted SF6 concentration averaged over all zones and cases was within 10 % of the average measured concentration. Excluding the bathroom zone, the overall average predicted concentration (115 μg/m3) was essentially identical to the overall average measured concentration (116 μg/m3).