Dynamic insulation has been used in non domestic buildings for 20- 30 years in order to reduce the heat loss and to bring preheated air into the buildings. Dynamic insulation means a construction where the air is being forced through the insulation, usually from the colder outside air into the heated building. The Norwegian Building Research Institute has been engaged to evaluate 12 row houses, with dynamic insulation used in the roof, which has been built in the Oslo area. 4 of the houses were monitored over a period of time.

The work concentrated on estimating the effects of building leakages and terrain parameters on the air infiltration. The analysis was performed mainly using a multi zone airflow model Movecomp with which the building and its ventilation system could be described in detail. The computations were performed for a flat in a 418-storey building. The highest infiltration occurred in an untight two-facade flat in open terrain. The calculations gave valuable information on the effect of the location of the leakage.

Disadvantages and advantages with different heating and ventilation systems in modern housing have been discussed during many years in Sweden. The discussion has intensified for modem low energy houses, where the use of forced air heating has increased during the last fifteen years, mostly in one-family houses. In many articles and the general debate diverging opinions have been presented concerning the thermal comfort, the air quality, the ventilation and the energy use in modern one-family houses with forced air heating.

The IEA Annex 27, "Evaluation and Demonstration of Domestic Ventilation Systems" is aiming at developing tools by using the most developed computer models and equations available including modul development. Before staring up all the simulations an in depth review of the variables influencing the evaluation of a ventilation system have been done and a report is to be published. All parameters are needed to be mapped so that realistic assumptions can be made for the simulation phase.

A study was set up to compare the effectiveness of passive stack ventilators (PSV) with mechanical extract fans (MEF) in providing adequate ventilation in UK homes. New build and refurbished homes with PSV and MEF were identified and questionnaires posted to 3000 households of which 1223 were returned. The survey showed that in homes installed with a PSV system, only 7% of those in the kitchen and only 8% of those in the bathroom were reported as blocked up. There were also few cases in which the MEF was blocked up or disconnected: 1.5% in kitchens and about 5% in bathrooms.

There is an increasing concern at the possible health effects of fine suspended particulate (aerosol) upon human health, particularly in the urban environment. Aerosol infiltrating indoors may arise from transport, power generation and natural sources. Aerosol also arises from indoor sources, through cooking processes for example, and from animal dander. In zones within a building, within which the air is reasonably well-mixed, the levels of aerosol will depend upon the ventilation rate and the rate of deposition on indoor surfaces.

The Building Research Establishment is currently investigating the impact of various radon remedies at a radon affected test house. Tests aim to assess how different ventilation strategies affect indoor radon levels and the building environment. Those examined include natural underfloor ventilation, mechanical underfloor ventilation (supply and extract), and whole house pressurisation. The test house has a suspended timber floor with an inaccessible underfloor space and is typical of much of the UK housing stock except for indoor radon levels regularly in excess of 1000Bqm^-3.

Almost 60% of French residential buildings were built before the seventies, and an important part of those is to be retrofitted for complying with new needs with regard to acoustic insulation and energy saving. Retrofitting modifies the airtightness of the building envelope and can lead to an insufficient air change rate in passive stack ventilated buildings ; the existing ventilation system has therefore to be redesigned in order to insure adequate indoor air quality.

Airtightness and infiltration rate measurements in office and other commercial buildings have shown that these buildings can experience significant levels of air leakage [1,2]. The energy impact of air leakage in U.S. office buildings was estimated based on the analysis of a set of 25 buildings used in previous studies of energy consumption [3,4]. Each of these buildings represents a portion of the U.S. office building stock as of 1995.

Air flow measurements and simulations were made on a 13-story apartment building to characterize the ventilation rates for the individual apartments. Parametric runs were performed for specific conditions, e.g., height, orientation, outside temperature and wind speed. Our analysis of the air flow simulations suggest that the ventilation to the individual units varies considerably.