One of the main aspects determining the thermal behaviour of buildings concerns the distribution and circulation of air. Experimentation was undertaken in the context of the investigation of a method of measurement of the natural ventilation of large rooms. The first objective was to endeavour to characterise the atmospheric conditions around the building, namely, conditions related to wind factors, but also those concerned with the location of the building in relation to neighbouring obstacles (other buildings, relief of the ground, etc).

Wind towers (scoops situated on the roofs of buildings to catch the wind) have been in use for centuries in the Middle east and Pakistan, to provide ventilation and cooling with minimal mechanical plant. In Europe, the problem of cooling buildings has generally not been significant, but in recent years there has been a trend towards substantial increases in internal heat gains from IT equipment etc., and overheating in summer has become one of our major concerns.

Natural ventilation studies were carried out within the frame of PASCOOL EC Research Project. Research on this topic included experimental and modelling work aiming to fill the existing gaps in our knowledge of indoor air conditions in naturally ventilated buildings. Experiments were carried out in full scale and test cell facilities during the summer period. Single sided and cross ventilation as well as air flow through large internal openings were the basic topics that were studied. Existing models were validated and new ones were developed.

The suitability of night ventilation for cooling for the UK is first assessed by presenting plots of summer weather data on the bioclimatic chart for three locations within the country. These indicate that most of the external weather conditions lie within the thermal mass and ventilation effectiveness areas of the charts. To confirm this, thermal simulations of a typical office module under a variety of internal conditions and summer weather data were performed.

Water use is distributed throughout building structures. Energy used to pump the water to higher levels in the building is not currently recovered, and is dissipated by performing work on air in the ventilation system which is vented to the atmosphere, when the water is discharged into the drainage stack. This energy can be utilised productively, however, by strategically placing the air inlet for the drainage stack inside the building, thereby utilising the potential energy stored in the water to draw air through the building.

Wind pressures can significantly affect ventilation performance. However often they are overlooked in the design of a naturally ventilated building, with buoyancy forces presumed to offer the worst case scenario for design. The result is that airflow patterns and the ventilation performance of the building is often different from the design intent. Successful natural ventilation design requires careful consideration of the building form, and so must involve the architect at the early stages of fabric development.

Traditional air-handling unit (AHU) control systems link the position of the exhaust air damper, recirculation air damper, and outdoor air damper. Tests at the National Institute of Standards and Technology (NIST) on a variable-air-volume (VAV) AHU have shown that air can enter the AHU through the exhaust air damper. This can negatively impact indoor air quality if the exhaust air duct is located near a pollution source. This paper presents a new control system for variable air volume AHU's that use volume matching to control the return fan.

Especially in modern buildings with small capacity of humidity storage it is necessary to reduce the humidity in the supply air. Normally this was done by using a refrigeration system mostly with CFC's. There are some alternative fluids available, but mostly they show a high global warming potential. All these systems need electrical energy to be driven and therefore it is necessary to consider other possibilities with alternative systems. The most promising systems are sorptive systems that are used now in open cycles.

Many dwellings with natural or gravity ventilation systems suffer from poor airchange rates. In Sweden, especially houses built in the 1960-ies and 1970-ies heated with electric resistance heating and thus without chimneys, are at risk. Improving the airchange rate in these houses is to some extent performed to decrease Radon gas concentrations where appropriate. For comfort, most homeowners learn to live with low airchange rates, accepting e.g. odours or window condensation and trying to compensate this with increased airing.