States heat load on buildings due to wind is dependent on the shape of building, wind direction and wind speed. Gives theoretical calculation for the heat loss due to wind based ongerman standard DIN 4701. Discusses fundamentals of fluid dynamics and the practicalities of wind tunnel tests. Recounts tests made of a block of flats in Munich. Pressure distribution due to wind was determined by a wind tunnel test on a model, giving c-profiles for different wind directions.
Describes how a family of simulated neutral atmospheric surface layers was used to determine the response of the wind loads on a building model, as well as the associated flowfield near it, to variations in the characteristics of these 'test boundary layers'. Results include the variation in the size of the horse- shoe vortex at the base of the building, spectra of pressure fluctuations, and documented variations in the wake Strouhal frequency with changing boundary layer characteristics.
Describes the ventilation of buildings by analogy with electric circuits and derives expressions for ventilation with and without flow through ducts in the roof. Finds that in general ventilation rate will vary linearly with wind velocity. Considers the effect of shelter belts on wind velocity and derives expression for sheltered ventilation rate. Suggests that eddy motion caused by shelters may be important. Gives measurements made on models in wind tunnels to show the affect on wind pressure of sheltering buildings at various distances.
Reports wind-tunnel tests on simple cubical model made of plastic to see effect of outside wall leakage on internal and external pressures. Three wind directions are studied and results extended to smoke-control problems. A method has been developed to modify the roof-vent design calculations to takewind effects into account. Shows failure of vent systems may bemore common than would be expected from current design methods.Concludes that leakage characteristics do not have any appreciable effect on outside wind pressures but do affect strongly the internal pressures.
Reports measurements made of wind pressures on a multi-storey building in London. Autocorrelations and power spectra were computed for the 48 pressure transducers and showed noticeable fluctuations in the pressures on the windward face, Possibly caused by a cushioning effect in front of the building "leaking" away at regular intervals. Mentions effect of the permeability of building. Comparisons made with wind tunnel tests improved when surrounding buildings were taken into account. Recommends design gust durations for various sizes of building.
Reports wind tunnel tests made on model building. Wind pressures on the models were measured using several manometers in holes on the windward side and a single manometer on the leeward side atwind speeds of approximately 35 feet and 45 feet per second. Single models and single models with a shielding building at varying distances were tested, and pressure distribution found.Comparison with full-scale tests indicates the general form of pressure distribution is the same but pressure reduction on leeward side is greater in full-scale test.
Treats measurements of ventilation rates in a model building and wind tunnel. 2 types of opening, circular holes and model windows were tested under 2 wind cOnditions. one wind condition was selected to give maximum flow through the model; with theother, ventilation was mainly due to turbulent pressure fluctuations. Illustrates different characteristics of theopenings. Draws comparisons between measurements and theoretical predictions. Discusses use of wind tunnels for ventilation studies. NOTES: A further comment on this paper was published in Building and Environment vol.15 no.141.
Analyses wind pressure records, taken during 5 different windstorms on 2 levels in a 400ft (122m) high office building in downtown Montreal March 1964 pressure fluctuations on an actual building. Preliminary work done to compare full-scale measurements with wind tunnel measurements indicates that simulation of basic statistical properties of wind pressure fluctuations can be successful when carried out in a boundary layer type of wind tunnel.
Wind pressure measurements made over a 4 years period on a 34-storey building in downtown Montreal were used to obtain data for checking and improving wind tunnel techniques of modelling flow characteristics of wind and aerodynamic behaviour of buildings. Specifies the major problems involved in making field measurements and in comparing them with wind tunnel measurements. Comparisons with model measurements are made. Examples have been found of excellent agreements, but for some wind directions the comparisons gave unsatisfactory correlation.
Discusses current knowledge concerning wind-induced ventilation in buildings. states major difficulty in estimating ventilation and infiltration rates in a building is ignorance of wind pressure distributions around structures. Examines properties of wind with special reference to mean velocity profiles, characteristics of turbulence and wind energy spectrum. Reviews internal and external pressure distributions on an isolated building. Studies effect of grouping of buildings on pressure distribution around a house by considering results of wind tunnel tests.
Login