Research over the past five years has indicated that a significant majority of the cost of residential retrofit duct sealing is in the labor required to find and seal those leaks. This paper describes the results of a field investigation of the performance and practicality of sealing residential duct leaks from the inside by means of a technique based upon injecting a fine aerosol spray into the duct system. The field results presented are from 4 7 houses located in Florida.
Occupancy sensors have the potential to significantly reduce energy use by switching off electrical loads when a normally occupied area is vacated. While occupancy sensors can be used to control a variety of load types, their most popular use has been to control lighting in commercial buildings. Manufacturers claim savings of 15% to 85%, although there is little published research to support the magnitude or timing of reductions.
Procedures were developed and tested to conduct a quick and reliable evaluation of weatherization program energy savings using heating system nm-time loggers. This project performed: (1) a statistical analysis to determine the measurements and assessment constraints on short-term nm-time monitoring, and (2) a field test of the data collection procedures with three weatherization providers.
Real-time ventilation and infiltration measurements were made on ten single-family homes. Seven of these had crawlspaces and were in the Pacific Northwest Two had daylight basements and were also in the Pacific Northwest. The other is an energy efficient demonstration "smart" house built in Rocklin, CA, and was built on a crawlspace. All of the homes were tested under heating season conditions. The home in Rocklin was also tested under cooling conditions. Each house was divided into multiple zones, including buffer spaces, and each test period lasted about a week.
Login