BD2011

Building and ductwork airtightness represent a key challenge towards very-low energy buildings and therefore towards the ambitious 2020 targets set in the recast of the energy performance of buildings directive. Results of the EU ASIEPI project (www.asiepi.eu, [6]) have shown that for most European climates, leaky envelopes and duct systems...

The objective of the WTA* data sheet “Air tightness in existing buildings” is to support planners and contractors in modernizing and renovating buildings. Taking existing standards and regulations into account, the data sheet features the analysis of existing buildings, professional planning and implementation, as well as air tightness...

This presentation will give an introduction to the approach of determining the required number of testing fans when conducting air tightness measurements of large buildings. From experience in testing practice and recording measurement results, we know that large buildings regularly achieve significantly better test results than...

The manufactures tests of windows in Europe are executed in accordance with the CE-directive. Air- and water tightness testing are performed in accordance with EN 1026 and classified in accordance with EN12207. Air- and water leakage measurements are performed under laboratory conditions using a test chamber and...

The Association for Air Tightness in Buildings (FLiB e.V.) offers air tightness testing teams the possibility to check their testing performance as well as that of their equipment. Round-robin tests allow the participants to conduct independent air-tightness tests in a building organized by the association. The test, in accordance with...

During the BlowerDoor building test, it must be ensured that all building parts of the test building or the test section have air connection, and that the test object can be considered one single zone. This also applies to large buildings like office buildings, schools, indoor pools, etc. with several floors and winding floor plans. Overly tight airflow...

The round-robin test of Czech airtightness providers was organised in order to obtain information about the measurement equipment generally used and in order to compare the test results given by different technicians operating with different devices. All the participants measured the same building under very similar conditions. The preparation...

The contribution informs about the foundation of a professional network of Czech airtightness test providers and gives basic information about the organisation and activities of this association.An idea of closer cooperation between Czech building airtightness test providers has existed for several years. (one outcome of such activities...

The actual question is as follows: “Is the building envelope of the first passive house in China sufficiently airtight?” To determine air-tightness in China, a pressure differential test was to be conducted. First, a number of questions had to be answered. What building system is used and which materials are implemented? Who will...

The new Part 7 of the Thermal Insulation Standard DIN 4108 describes the permanent design of the airtight layer of heated or air-conditioned buildings. In the chapter on requirements, some terms have been redefined. However, the required values for the maximum air change rate are stipulated in the current EnEV...