Two bi-level houses in Gaithersburg, Maryland, USA, of identical design and construction were studied to determine the relationships among air exchange, energy consumption, and indoor pollutants. The experimental house was retrofitted and equip
This literature survey contains references pertaining to the physical properties of radon and its daughters, instrumentation for their measurement, health effects, surveys and measurements, and regulatory information.
The Linford project involved designing, building and monitoring 8 low energy passive solar houses. The houses were insulated to current Danish Regulation standards. Seven occupied and 1 unoccupied test house were monitored over two years.
Discusses strategy for dealing with indoor air pollution in office and similar buildings, including verification of the mechanical ventilation system, measurement of building pressure, problems due to stack effect, presence of moisture. Suggests that the causes and cures of indoor pollution are diverse and surprisingly simple. Mechanical ventilation systems should be less complex, have dynamic stability and correct uncontrolled excessive moisture.
The aerodynamic forces affecting wind and rain penetration of roofs are described. They are: 1 the wind and its turbulent nature, 2 the induced pressure field, 3 the air flows in contact with the roof and 4 the characteristics of the roof (internal pressure, permeability, structure, etc).
Summarises the issues discussed at the Indoor Air '84 conference in Stockholm. The main topics include sick buildings, organic compounds, formaldehyde, combustion products, and radon.
The typical infiltration load for a residential building has been found to range from one-third to one-half of the total space conditioning load. However, most infiltration measurements have been made on single-family houses.
To elucidate any connection between high radon concentrations and low-infiltration houses, the 222Rn concentrations and infiltration rates have been measured concurrently in US houses. Three housing surveys have been undertaken: one in energy-efficient houses located throughout the US and twoin conventional houses in the San Francisco area and in Maryland. In each of the groups surveyed, no clear correlation was observed between 222Rn concentrations and infiltration rate, although each parameter varied over a wide range.
Increased air tightness in new energy-efficient housing has led to serious problems with excessive indoor moisture in winter as well as with other trapped indoor air contaminants. Heat recovery ventilation systems are being used increasingly
Addresses air leakage of warehouses and light industrial buildings including the significance of infiltration/exfiltration, air leakage sites, and measurement techniques. Concludes that 1, only limited leakage data are available for components of this building category 2, no model has been developed specifically for use in warehousing and light industrial buildings. However, one of the existing models for residential buildings could possibly be adapted.
Login