An implementation of a Condensation, Damp and Mould (CD&M) Strategy for the Thamesmead estate in south-east London Targeting 2000 homes. The evidence-based strategy is designed to manage CD&M systematically and focus on homes that will not be refurbished or replaced for some time. CD&M risk assessments and surveys are used to identify homes for a range of interventions, including energy advice, smart heating controllers and demand-controlled mechanical extract ventilation, in various combinations.

As policy makers strive to reduce the energy demands of houses by reducing infiltration rates, an unintended consequence could be a fall in the quality of indoor air with corresponding negative health effects at a population scale. Measuring pollutant concentrations in-situ is difficult, expensive, invasive, and time consuming and so the simulation of indoor conditions, using representative models of a housing stock, is a more common method of investigation.

Surface condensation risk is a fact that has to be dealt with when buildings are airtight. Airtight buildings with lower ventilation rates are the result of applying energy saving policies and criteria. Surface condensation risk depends greatly on the ventilation rates, as well as on another factors such as generation of water vapour, climate, envelope components and U value, etc.

This study evaluated the emission characteristics of ultrafine particles emitted during material extrusion type 3D printer, called Desktop 3D printer, operation in the test bed and mock-up environmental conditions respectively. For the measurement, a condensation particle counter (CPC) and scanning mobility particle sizer (SMPS) were employed. In the test-bed evaluation, representative materials widely used nowadays such as ABS, PLA, TPU, PC, etc, emitted higher than the UFP criteria (3.5 ×1011) of 2D printer test method RAL-UZ 171.

This study is designed to investigate the particulate matter removal efficiency of domestic air cleaner products and seeks to compare the particulate matter removal efficiency in a laboratory with that in real life. 

Bio-based insulation materials represent an alternative to petro-based materials which may contribute to enhance buildings energy efficiency. Nevertheless, these material must respond to indoor air quality requirements and prove their resistance to moulds. In this study, VOCs emissions of a wood fibre board were characterised at 50% and 85% of relative humidity (RH) as well as its potential to mould growth. Relative humidity variation impacted significantly some VOCs emissions and colonies from Aspergillus niger developed onto the material.

Cooking activities generate massive fine particulate matter (number concentration). Effective ventilation system can improve the indoor air quality impacts of pollutants from residential cooking. Make-up air supply system can improve the range hood and Indoor air quality. In this study, we measured a capture efficiency of range hood with make-up air supply and indoor particles during cooking activates. For household’s comfort, make-up air supply was installed the line diffuser type. Case 1 PN concentrations increased to around 60,000#/cm3.

In recent years, PM, which is one of the most important indoor air pollutants, has attracted a great deal of attention. PM is mainly generated by occupant activities. In particular, cooking and smoking are occupant activities that have the greatest effect on the indoor PM concentrations. The objective of this study is to analyse indoior PM concentration and occupant behavior of Korean residential buildings. PM concentration increased rapidly in a short time during the cooking process.

Recently, many studies have focused on the adsorption of pollutants as a method for improving indoor air quality. In Korea, the Health-Friendly Housing Construction Standards specify requirements for the installation of pollutant-absorbing materials. It is recommended that at least 10% of the total area of the living room and bedroom walls be covered. However, current guidelines regarding the installation locations of the adsorption material are unclear.  

The research objectives of this study are to develop and validate a detailed simulation model of a test cell which was used to measure heat balances for comfort evaluation.