A68

Highly energy efficient buildings such as ones built to the Passive House standard, require a very airtight building envelope and the installation of a mechanical ventilation with heat recovery (MVHR). MVHR systems incorporate ambient air filters, which reduce the introduction of particulate matter (PM) from outdoor sources into the dwelling. However, indoor PM sources, e.g. cooking, can also contribute substantially to occupants’ exposure and need to be accounted for when designing ventilation or deriving recommendations for filter classes. 

The current policies and regulatory frameworks in the construction sector aim to improve energy efficiency of new buildings whilst maintaining acceptable level of indoor environmental quality (IEQ) including indoor air quality (IAQ). In practice, however, there are often important trade-offs between these objectives. The aim of this paper is to investigate the concentrations of volatile organic compounds (VOCs) in a recently built residential block in the UK and the potential trade-offs between ventilation rates and VOCs.

Mechanical ventilation has become a mandatory requirement in multiple European standards addressing indoor air quality (IAQ) and ventilation in residential dwellings (single family houses and low-rise apartment buildings). This article presents the state of the art study through a review of the existing literature, to establish a link between ventilation rate and key indoor air pollutants. Design characteristics of a mechanical ventilation system such as supply/exhaust air flow, system and design of supply and exhaust outlets were considered.

One of the key objectives of the IEA Annex 68 research programme entitled “Indoor Air Quality Design and Control in Low Energy Residential Buildings” is to provide a generic guideline for the design and operation of ventilation in residential buildings. They need to have minimal energy consumption, and at the same time maintain a high level of Indoor Air Quality (IAQ). The paper reports on preliminary results of an interview survey conducted among different stakeholders involved in design, installation and operation of residential ventilation in countries involved in the Annex.

The objective of present work was to develop the metric that assess the performance of solutions securing high indoor air quality in low-energy (modern) residential buildings. This was achieved by summarizing data on the levels and types of gaseous pollutants and particulate matter in low-energy buildings and comparing them with the existing exposure limits for pollutants.

Subtask 1 of IEA EBC Annex 68 will aim at defining the metrics to enable a proper consideration of both energy and IAQ benefit in building design and operation

The overall objective of the IEA EBC Annex 68 is to provide scientific basis usable for optimal and practically applicable design and control strategies for high Indoor Air Quality (IAQ) in residential buildings. Naturally, those strategies should ensure minimal possible energy use. The project aims to gather existing and provide new data on pollution sources in buildings, model the indoor hydrothermal conditions and air quality as well as thermal systems, and will look to ways to optimize the provision of ventilation and air-conditioning.